Installation Instructions

Important remark under Windows 98SE

♦ If the “Please insert the disk labeled “Windows 98SE/ME CD-ROM”, and then click “OK”

Window appears, insert your Windows CD-ROM and enter the path corresponding to the CD-

ROM drive then click “OK”. Click “Finish” to complete the installation, which will restart

Windows.

Configuration of your Wireless LAN USB to access to Internet

After the two previous steps completion, your Wireless USB LAN adapter is now installed. You now

have to configure your connection to be able to access via an access as seen below.

INTERNET

Access

Point

Client 1

Client 2

Client 3

To do that, you will have to:

♦ Launch the WLAN Utility management software

♦ Configure your adapter in Infrastructure Mode

♦ Set the SSID of the wireless network on which you want to attach

♦ Configure the encryption parameters if you want to protect your wireless network

I. Configuration to access to à Internet under Windows :

At first, you must verify that the computer, where you have installed your USB adapter is

configured in DHCP (dynamic address) :

♦ In the Network Connection tab of the Control Panel menu, click on the TCP/IP protocol

of the Wireless network connection (SAGEM Wi-Fi 11g USB ADAPTER).

♦ Select Obtain an IP address automatically in the IP Address tab.

Open the WLAN utility

To open the WLAN utility, you have two possible choices:

♦ Select the “SAGEM Wi-Fi 11g USB adapter LAN Utility” from the

Start Menu of Windows,

♦ Or double-click the corresponding icon laying on the Windows

SAGEM Wi-Fi

11g USB adapter

LAN Utility