Operation Manual

4
Configuration of your to access to Internet
After the two previous steps completion, your Wireless LAN (Local Access Network) is now
installed. You now have to configure your connection to be able to access via an access as seen
below.
INTERNET
Access
Point
Client 1
Client 2
Client 3
To do that, you will have to:
♦ Launch the WLAN Utility management software
♦ Configure your in Infrastructure Mode
♦ Set the SSID of the wireless network on which you want to attach
♦ Configure the encryption parameters if you want to protect your wireless network
I. Configuration to access to à Internet under Windows :
At first, you must verify that the computer, where you have installed your CARDBUS is configured
in DHCP (dynamic address) :
♦ In the Network Connection tab of the Control Panel menu, click on the TCP/IP protocol
of the Wireless network connection (SAGEM Wi-Fi 11g CARDBUS ADAPTER).
♦ Select Obtain an IP address automatically in the IP Address tab.
Open the WLAN utility
To open the WLAN utility, you have two possible choices:
♦ Select the “Sagem WL5021-F Cardbus 802.11g” from the Start
Menu of Windows,
♦ Or double-click the corresponding icon laying on the Windows
desktop :
Sagem WL5021-F Cardbus
802.11g