Technical information

 Technical Site Documentation - myX-4
________________________________________________________________________________________________
Ref. SCT U38 SSC DTS 0022 – Index A - July 30, 2004 Page 6-44
Before any operation,
-flux correctly the pins of the connector.
-with the solder wick loaded with tin , tin the pins of the
DATA/ AUDIO/ CHARGE connector by positioning it
straight ahead (pads upward), and by heating the solder
wick which is in touch with pins.
Attention:
- At the end of the operation , verify that there is no short
circuit between pads.
-Start soldering the connector pins.
-Flux the place of the connector and position the DATA/
AUDIO/ CHARGE connector.
-Verify that the pins of the DATA/ AUDIO/ CHARGE
connector are well centred on pads.
-Heat pins with an air blow device while maintaining the
connector with tweezers
-Verify that there is no short-circuit, that solders are shiny
At last, solder the 4 pins crossing the board..