Technical information

Procedure
Proc 0 01
Proc 1 01
Proc 1 02
Proc 1 03
Proc 1 04
Proc 1 05
Proc 1 06
Proc 1 07
Proc 1 08
Proc 1 09
Proc 1 10
Proc 1 11
Proc 1 12
Proc 2 02
Proc 3 01
Proc 3 02
Proc 4 01
Symptom
Symp 01
Symp 02
Symp 03
Symp 04
Symp 05
Symp 06
Symp 07
Symp 08
Symp 10
Test
Test 01
Test 02
Test 03
Test 04
Test 05
Test 06

Fiche Proc 4
01
M 2005
5(03/$&(0(17&211(&7(85
)21''(3267(
3/3

Before any operation,
-flux correctly the pins of the connector.
-with the solder wick loaded with tin , tin the pins
of the DATA/ AUDIO/ CHARGE connector by
positioning it straight ahead (pads upward), and
by heating the solder wick which is in touch with
pins.
$WWHQWLRQ

- At the end of the operation , verify that there is
no short circuit between pads.
-Start soldering the connector pins.
-Flux the place of the connector and position the
DATA/ AUDIO/ CHARGE connector.
-Verify that the pins of the DATA/ AUDIO/
CHARGE connector are well centred on pads.
-Heat pins with an air blow device while
maintaining the connector with tweezers
9HULI\WKDWWKHUHLVQRVKRUWFLUFXLWWKDW
VROGHUVDUHVKLQ\DQGWKDWWKH\FRYHUZHOOWKH
SLQV
At last, solder the 4 pins crossing the
Contents REF MTB DTS 8- Indice B - February 21 2006 Page 5-30