Technical information


Fiche Proc 1 09
myC2-3
5HPRYHDQGSODFHWKHHTXLSSHG
IODS
1/1
7RROV
- Tool of retreat hinge (252081336)
3UHOLPLQDU\RSHUDWLRQ

1. Remove the battery (Proc sheet 0 01).
2. Remove the lower housing of mobile (Proc sheet 1 01).
3. Remove the keyboard (Proc sheet 1 04))
4. Remove MMI board (Proc sheet 1 07).
5HPRYDOSURFHGXUH
1. Maintain the flap and the upper housing in about 90 ° (1).
2. Use the tool ( 2 ) code 252081336 to disengage the hinge ( 3 ).
3. Take off the connector from FPC( 4 ) take care of not damaging him
4. Now flap and hinge are dissociate from the upper housing.
3ODFHPHQWSURFpGXUH

1. Engage the FPC in the upper housing (4).
2. Position the flap and his hinge equipped (5) in the upper housing (3).
3. Lock the hinge. Check the flap well opens and locks by testing it several times. You way
not find any difficulties while opening or locking.
)XUWKHURSHUDWLRQV

1. Place the keyboard ( Proc sheet 1 04).
2. Place the board MMI (Proc sheet 1 07).
3. Place the lower housing of mobile (Proc sheet 1 01).
4. Place of the battery (Proc sheet 0 01)


Risk of the procédure :
Damage the FPC
Damage plastic component



Procedure
Proc 0 01
Proc 1 01
Proc 1 02
Proc 1 03
Proc 1 04
Proc 1 05
Proc 1 06
Proc 1 07
Proc 1 08
Proc 1 09
Proc 1 10
Proc 1 11
Proc 1 12
Proc 2 02
Proc 3 01
Proc 3 02
Proc 4 01
Symptom
Symp 01
Symp 02
Symp 03
Symp 04
Symp 05
Symp 06
Symp 07
Symp 08
Symp 10
Test
Test 01
Test 02
Test 03
Test 04
Test 05
Test 06
Contents REF MTB DTS 8- Indice B - February 21 2006 Page 5-16