Technical information


Proc Sheet 1 04
myC-3/ myC-3b
REMOVING / REPLACING THE METAL DOME
1/2
Ref. SCT U38 SSC DTS 0020 – Index A - May 4, 2004 Page 5-19
4.31 Tools :
- Cross shaped screwdriver
- Gloves
- Metal dome Jig
Tweezers
4.32 Preliminary operation
This procedure must be performed by a technician with gloves.
1. Remove the battery pack ( Proc sheet 0 01).
2. Remove the back cover ( Proc sheet 1 01).
3. Remove the equipped electronic board ( Proc sheet 1 06).
4.33 Removal procedure :
1. Remove the metal dome (2) of the equipped electronic board (1)
4.34 Placement procedure :
Warning : The metal dome is not reusable, it must be necessarily replaced by a new metal dome,
unless the board is swapped and sent as level 3
1. Replace the new metal dome (2) on the equipped electronic board (1), using the metal dome jig.
2. Place the equipped electronic board in its housing
4.35 Further operations :
1. Replace the equipped electronic board ( Proc sheet 1 06).
2. Replace the back cover ( Proc sheet 1 01).
3. Replace the battery pack ( Proc sheet 0 01).
4. Carry out the radio test (Test Sheet 04).