Technical information


Proc Sheet 4 01
myC3-2
5HPRYHDQG3ODFHWKH,2FRQQHFWRU
1/3
1RWLFH The handsets requiring the replacement of system connectors cannot be repaired under
Sagem warranty.
The eventual deterioration of the board due to a bad replacement of the connector fall under the
Repair Centre responsibility.
5HSODFHPHQWSURFHGXUHRI'$7$$8',2&+$5*(FRQQHFWRU
1-Disassemble the handset ( Proc Sheet 1 20 )
2-Replace the defective connector (see below) 5HI
3 - Replace the electronic board in the mobile phone ( Proc Sheet 1 20 )
4 -To test the replacement of the connector, it is necessary to:
a) Connect the mobile phone on SMT maintenance software (test Sheet 01)
b) Make real calls with a pedestrian handsfree Kit 5HIHUHQFH
c) Test the charge of mobile phone
5 - Standard test after repair


Procedure
Proc 0 01
Proc 1 01
Proc 1 02
Proc 1 03
Proc 1 04
Proc 1 05
Proc 1 08
Proc 1 10
Proc 1 18
Proc 1 20
Proc 1 22
Proc 2 01
Proc 2 03
Proc 3 01
Proc 3 02
Proc 4 01
Symptom
Symp 01
Symp 02
Symp 03
Symp 04
Symp 05
Symp 06
Symp 07
Symp 08
Symp 10
Test
Test 01
Test 02
Test 03
Test 04
Test 05
Test 06
Contents REF MTB DTS 1- Indice D - November 10 2005 Page 5-32