Technical information


Proc Sheet 2 01
myC-1
REMOVING / REPLACING THE MICROPHONE
1/2
Ref. SCT U38 SSC DTS 0016 - Index A – May 6, 2004 Page 5-24
6.38 Tools :
- A 0.6mm torx screwdriver
- Soldering iron
6.39 Preliminary operation
1. Remove the battery pack ( Proc sheet 0 01).
2. Remove the back cover ( Proc sheet 1 01).
6.40 Removal procedure :
1. Unstick the ground tape (2) of the electronic board (1)
2. Turn the electronic board (1) round to liberate it from the front cover
3. Unsolder the microphone (2) on the electronic board (1)
4. Remove the microphone (1)
6.41 Placement procedure :
1. Replace the microphone (2) in its housing
2. Flux the place of the microphone contact (3) and solder it on the electronic board (1)
3. Position the electronic board (1) in its housing
4. Stick the ground tape (2) on the electronic board (1) by fixing correctly on the radio shielding
Nota: If the ground tape have been damaged during operations, change automatically the LCD foam
for ESD.
6.42 Further operations :
1. Remove the back cover ( Proc sheet 1 01).
2. Remove the battery pack ( Proc sheet 0 01).