Technical information


Proc Sheet 1 03
myC-1
REMOVING / REPLACING THE METAL DOME
1/2
Ref. SCT U38 SSC DTS 0016 - Index A – May 6, 2004 Page 5-17
6.23 Tools :
- A 0.6mm torx screwdriver
- Gloves
- Metal dome Jig
Tweezers
6.24 Preliminary operation
This procedure must be performed by a technician with gloves.
1. Remove the battery pack ( Proc sheet 0 01).
2. Remove the back cover ( Proc sheet 1 01).
6.25 Removal procedure :
1. Turn the electronic board round to liberate it of the front cover
2. Remove the metal dome of the electronic board
6.26 Placement procedure :
Warning : The metal dome is not reusable, it must be necessarily replaced by a new metal dome,
unless the board is swapped and sent as level 3
1. Replace the metal dome on the electronic board, using the metal dome jig.
2. Place the electronic board in its housing
6.27 Further operations :
1. Replace the back cover ( Proc sheet 1 01).
2. Replace the battery pack ( Proc sheet 0 01).
3. Carry out the radio test (Test Sheet 04).