User manual

5-14
Operation
Sophisticated" copy
 Position the document (refer to paragraph Document depositing, page 5-1).
 Press key .
 Enter the required number of copies and confirm with the OK key.
 Using the keys  or  select the scan modes
1
DUPLEX->DUPLEX (Front/Rear) or
SIDE->DUPLEX or DUPLEX->SIDE or SIDE->SIDE and confirm with the OK key.
 If you have selected for printing the mode DUPLEX, select with the keys  or  LONG
BORDER
or SHORT BORDER and confirm with the OK key.
 Using the keys  or  select the resolution: ULTRA FAST, FAST, QUALITY or PHOTO and
confirm with the OK key.
 Using the keys  or  select the degree of contrast and confirm with the OK key.
 Using the keys  or  select the degree of brightness and confirm with the OK key.
 Select the collation mode COPY ASSEMBLED or NOT ASSEMBLED and confirm with the OK
key.
 Using the keys  or  or the numeric key pad or eventually the key dedicated for zoom set
up the degree of zoom between
25% TO 400% and confirm with the OK key.
 Using the keys  or  or the numerical key pad select the required base values and confirm
with the OK key.
 Using the keys  or  select the type of paper NORMAL PAPER or THICK and confirm with
the OK key.
 Using the keys  or  select the required paper tray, AUTOMATIC TRAY, UPPER TRAY or
LOWER TRAY and confirm with the OK key.
S
PECIFIC COPY SETTINGS
When the copy quality is no longer satisfactory, you can perform a calibration. To do so, refer to
paragraph Scanner calibration, page 6-15.
Moreover, a high number of controls let you improve the copy quality.
Scanner and printer settings
841 OK - ADVANCED FCT / COPY / RESOLUTION
 The Resolution parameter adjusts the photocopying resolution. Select Fast, Quality or Photo
resolution using keys
 or , then validate the choice with the OK key.
1. If you have previously installed the duplex module at the back of your terminal.