User manual

5-18
Operation
Date en cours : 29 juin 2004
D:\CLIENTS\sagem\Pour dossier MFK V2\MFK V2 LU 251597054A MF3760_3780 GB\Utilisation Gb.fm
846 OK - ADVANCED FCT / COPY / LUMINOSITY
The
LUMINOSITY parameter is used to make your original document lighter or darker. Adjust the
brightness required using keys
 and , then validate the choice with the OK key.
847 OK - ADVANCED FCT / COPY / BINDING
The
BINDING parameter is used to choose the long or short side according to the type of binding of your
document. Make your choice using keys
 and , then validate the choice with the OK key.
All settings made using this menu become default settings of the machine.
85 OK - ADVANCED FCT / SCAN. & PRINT
Use keys
 or  of the browser to scroll the setting described below that you want to modify.
Validate your setting by pressing the OK key.
851 OK - ADVANCED FCT / SCAN. & PRINT / PAPER
Select
NORMAL or THICK paper using keys and.
Validate your setting by pressing the OK key.
1) When
THICK paper type is selected, the print speed is slowed down.
2) Use the manual feeder for paper with a weight greater than 90 g/m
2
.
852 OK - ADVANCED FCT / SCAN. & PRINT / PAPER TRAY
Select the paper tray that you want to use;
AUTOMATIC, LOWER or UPPER using keys and .
Validate by pressing the OK key.
853 OK - ADVANCED FCT / SCAN. & PRINT / PAPER SAVE
This function prints all your documents duplex.
This function requires the prior installation on the rear of your machine of the duplex module and the
additional paper tray(option or depending on model).
Select WITH or WITHOUT using keys
 and.
Validate by pressing the OK key.
854 OK - ADVANCED FCT / SCAN. & PRINT / S.F MARGINS
If you want to offset the side margins of your document to the left or to the right when scanning with
your scroll scanner.
Adjust the offset of the left/right margins (in 0.5mm steps mm) using keys
 and .
Validate by pressing the OK key.
855 OK - ADVANCED FCT / SCAN. & PRINT / FLATBED MARG
If you want to offset the side margins of your document to the left or to the right when scanning with
your flat scanner:
Adjust the offset of the left/right margins (in 0.5mm steps mm) using keys
 and .
Validate by pressing the OK key.