User manual

Operation
5-13
Date en cours : 9 février 2005
C:\Documents and Settings\G097447\Bureau\MFK V2 LU 251 816 433A MF 3725 GB\Utilisation Gb.fm
Operation
Setting your
machine
Getting startedDirectoryMaintenanceSafety ContentsInstallationPrint function
SPECIFIC COPY SETTINGS
When the copy quality is no longer satisfactory, you can perform a calibration. To do so, please
see the paragraph on Scanner calibration, page 7-11.
Moreover, a high number of controls let you improve the copy quality.
Scanner settings
841 OK - ADVANCED FCT / COPY / RESOLUTION
 The RESOLUTION parameter adjusts the photocopying resolution. Select HIGH
SPEED, QUALITY or Photo resolution using keys
 or , then validate the choice
with the OK key.
842 OK - ADVANCED FCT / COPY / ZOOMING
 The ZOOM setting is used to reduce or enlarge part of the document by choosing the
original and the zoom value to apply to the document, 25 to 400 %. Enter the zoom value
required using the keys of the digital key pad. Validate the choice with the OK key.
843 OK - ADVANCED FCT / COPY / ASSEMBLED
 The ASSEMBLED parameter is used to define the choice of your printer outputs; either
assembled or not assembled. Validate the choice with the OK key.
844 OK - ADVANCED FCT / COPY / ORIGIN
If you wish, you can change the origin of the scanner.
By entering new values of X and Y given in mm (X < 210 and Y < 286), you will move the
scanning zone as shown on the figure below.
 Select the X and Y coordinates with keys  or .
 Set the required coordinates with the numeric keypad or  or .
 Confirm your setting by pressing key OK.
845 OK - ADVANCED FCT / COPY / CONTRAST
 The CONTRAST parameter is used to select the photocopy contrast. Adjust the contrast
using keys
 and, then validate the choice with the OK key.
scanned area
Top view: scanned side down
y
x
TOP OF SHEET END OF SHEET