User manual

Setting your machine
3-9
Date en cours : 9 février 2005
C:\Documents and Settings\G097447\Bureau\MFK V2 LU 251 816 433A MF 3725 GB\Configuration Gb.fm
SommaireInstallation
Operation
Setting your
machine
Getting startedDirectoryMaintenanceSafety ContentsInstallationPrint function
 Repeatedly press the keys or until OPTIONAL appears.
Press E
NTER.
 Press the > key.
 This example shows how to switch the TCP/IP protocol on to connect the terminal to the
network. You can switch Netware or EtherTalk on in the same way.
If TCP/IP is OFF. Press E
NTER, a blinking "?" appears. Select ON using the or keys.
Press E
NTER again.
Automatically configuring IP settings
You can make these settings when the TCP/IP protocol is on. We recommend that you manually
configure your terminal. However, local network settings can be automatically configured if you
have a DHCP or BOOTP server on your local network which can dynamically distribute
addresses to peripherals on the LAN.
To automatically configure network local settings:
MENU - - INTERFACE > - - TCP/IP > DHCP
 Press ENTER, a blinking "?" appears.
 Select ON using the or , then press ENTER.
 Press the MENU key.
Switch your terminal off and then back on again. You have now finished configuring the
IP address
Manually configuring IP settings
You can make these settings when the TCP/IP protocol is on.
To configure your terminal manually, you will need the usual information for setting up a
peripheral (IP address, subnet mask and gateway address).
To manually configure network local settings:
MENU - - INTERFACE > - - TCP/IP > DHCP
 Check that DHCP is set to OFF. If not press ENTER, then select OFF with the or . keys
Press E
NTER.
 Press .
 Press ENTER to enter the IP address. A cursor (_) starts to flash in the right-hand segment
(3 figures). Press the key to increment the value and the key to decrement it. Once
you have set the value for the right-hand segment, press the < key to place the cursor in the
next segment. Again, press the key to increment the value and the key to decrement
it. Proceed in the same way for all of the segments. Press E
NTER once all the segments have
been set up.
 Press .
 Enter the subnet mask address in the same way as for the IP address.
 Press .
 Enter the gateway's IP address in the same way as for the IP address.