Operation Manual

5 - Problem solving in USB mode

SAGEM F@st™ 908/948 Reference Manual - USB Interface – 288 055 881 - 01

Page

5-2

Reproduction and communication prohibited without written permission of E

5.1 Interpreting the LEDs visible on the modem cover

LED ADSL PWR

On steady

ADSL synchronized Modem powered up

Off

No ADSL sync Modem not powered

Blinking

Trying to set up ADSL

synchronization

Not applicable

5.2 Problem solving in USB mode

5.2.1 "ADSL" and "PWR" LEDs off

¾ Check that the USB lead is correctly connected to your computer (or to a HUB).

¾ Check that the drivers are correctly installed (refer to the reference manual - SAGEM F@st

908 / 948 USB interface and the sections dealing with the status of the modem in Windows

XP, MacOS 8.6-9.x or MacOS X).

Note: If your computer is connected to a hub, disconnect all the devices connected to isolate

your modem.

If there is no indication to help you solve the problem:

¾ Install again (refer to the reference manual - SAGEM F@st

908 / 948 USB interface and the

sections dealing with installation of the modem in Windows XP, MacOS 8.6-9.x or MacOS X).

5.2.2 "ADSL" LED off and "PWR" LED on

¾ Check that the line lead is correctly connected to your modem and to the telephone line.

¾ Check with your Internet access provider (IAP) that the ADSL service has been opened on

your telephone line.