Installation Instructions

SAGEM F@st
TM
908 / 948 Installation Guide
12
¾ Select your country of residence (depending on model ).
¾ Choose your Internet Access Provider in the suggested list.
Once the installation is done, you can go to the next stage.
3.2.1 Encapsulation options in Ethernet mode (depending on versions)
The encapsulation parameters are automatically set up, when the Internet Access Provider is
choosen in the list offered by the installation software.
Nevertheless, the possibility of set up parameters, related to an Internet Access Provider
which would not already been listed, has been provided for.
In that particular case, the selection «Other» from the Internet Access Provider list, opens a
control panel, which allows to choose the encapsulation.
The SAGEM F@st™ 908 / 948 modem supports three encapsulation modes:
¾ RFC 1483 Bridge,
¾ RFC 1483 Router DHCP,
¾ RFC 1483 Router static IP.
If your Internet connection must be set up in PPPoE mode, you will need to use
RFC 1483 Bridge encapsulation.
Refer to section 3.1 (connecting to the Internet (PPPoE connection mode) in the
Reference Manual - Ethernet Interface.
Please refer to the documentation or the subscription email from your Internet
access provider (IAP) to ascertain which encapsulation mode is appropriate to your
ADSL line.