Operation Manual
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page 5-73
Field Action
VPI/VCI
Displays the VPI/VCI specific to the "Bridge" connection
Connection Type
Displays the "Bridge" protocol
Service Name
Displays the name of the service: br_0_35_1
Service Category
Displays the type of service adapted to the traffic required
IP Address
In the "Bridge" connection, this field is: Not Applicable
Service State
Displays the status of the service: Enabled
NAT
Displays the status of the NAT: Disabled
Firewall
Displays the status of the firewall: Disabled
IGMP Multicast
In the "Bridge" connection, this field is: Not Applicable