User manual

You can carry out the following operations over a remote telephone:

Whilst listening:

• pause or resume message listening by pressing 5,

• go on to next message, by pressing 6,

• start listening to message again, by pressing 4,

• go back to previous message, by pressing 4 twice.

After listening:

• delete received messages, by pressing 1 and 5,

• record your announcement, by pressing 8 and 3 and stop the

recording of your announcement, by pressing any key,

• listen to your announcement, by pressing 3,

• switch on your answering machine, by pressing 7,

• switch off your answering machine, by pressing 9,

• resume message listening, by pressing 5.

9.PRIVILEGED ACCESS

PRIVILEGED ACCESS CODE

If you do not want to be disturbed by anyone except privileged access callers (with a special access code),

set the unit to TAD receive mode and input a privileged access code:

Press MENU, 4, 7 and START.

Input an access code other than 0000 and press START to confirm.

Note: You must activate the privileged access facility using MENU 48 (setting: WITH).

INCOMING CALLS

Only those callers to whom you have given this code will be able to reach you. They must:

Dial your number.

Wait for your terminal to answer the call.

Press the key, then enter the 4-digit privileged access code.

Note 1: If you do not answer the call, the caller will be prompted to leave a message on your TAD.

Note 2: The "remote message retrieval" and "privileged access" codes must be different. To de-activate

the privileged access facility, simply set the code to 0000.

Delete

Announce

4 5 6

machine

8 9

* 0

Answering

machine

Answering

OFF

Last

Message

Pause /

Message

Record

Liasse2_23227944-0.p65 07/06/2000, 11:4730