User guide

31 Troubleshooting
SAGEM F@st™ 1400 / 1400W
If access to the configurator is still impossible, you should carry out the following
instructions:
1. Check that the Ethernet or USB cable is properly connected at both its ends.
2. In the event of the USB being used, check that the USB Bridge/Router ADSL
peripheral is actually installed on your computer.
3. Check that your computer is configured in DHCP client.
In Windows
• Click on Start and then on Configuration
tab in Network Properties.
• Click on the wireless network card’s TCP/IP
protocol, then click on Properties.
The screen opposite will be displayed.
• Select the General tab, then the "Obtain an
IP address automatically" and "Obtain
DNS server address automatically"
command.
• Click on the OK button to validate your
choice.
In Mac
• Click on the Apple menu in the menu bar,
select System Preferences, then click on
the Network icon. The following screen will
be displayed.
• Select the TCP/IP tab.
The Configure field should display Using
DHCP by default.
If this is not the case, select this value by
means of the drop-down list.