Operation Manual

5
YOUR TELEPHONE
Connecting the base
Place the base where it should be located.
Plug the telephone line connector (as shown
in the illustration) into the telephone socket
on the underside of the base and connect the
other end to the telephone wall socket.
Connect the power connector on the
underside of the base and the other end of
the cord to the power socket. The power
supply indicator located on the base is green.
Place the base in its final location.
Handset set-up
Insert the batteries making sure to respect
the polarity. Place the cover back on the
handset by pushing upwards until it is
completely closed.
Remove the protective film on the screen,
place the handset on the base to fully charge
the batteries.
The charging icon appears on the screen, it
indicates the charging status. Once the icon
is full, your batteries are charged.
Before making any connections, please refer to the safety instructions presented at
the beginning of this user guide.
Only use certified rechargeable batteries. For optimal battery charge, leave the
handset on the base for at least 6 hours during initial use. During charging, the
batteries may heat up, this is quite normal and without risk.
Power socket
Telephone socket
LU D85C UK.book Page 5 Jeudi, 16. décembre 2004 5:30 17