Operation Manual
38
SETTINGS
On the base:
Put the base to which you want to link the
handset in registration mode and press the
base button for several seconds.
The green light blinks rapidly, the base is in
registration mode.
The new handset and the base are mutually
searching for each other. The registration
may take several seconds.
Once the handset is registered, the handset
automatically exits the registration mode and
lets you know the registration is done.
BASE SETTINGS
Using a handset to put the base
in registration mode
This function enables you to put the base in
registration mode so you can register a new
handset. To do so, the handset to be
registered must be in registration mode (refer
to paragraph Registering a new handset to
a base, page 36).
On the navigator key , press or
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using or .
Press Valid. .
You can also set your base to the
registration mode using a handset
already registered by selecting the
Registration function in the menu
SETTINGS/ADVENCED SET/SET
BASE.
Select SET BASE using or . Press
Valid. .
Select REGISTR.MODE using or .
Press Valid. .
A screen prompts you to confirm the setting
of the base to the registration mode. Press
Yes to enter the registration mode. The
indicator light on your base starts to quickly
blink green.
Your base will remain in registration mode for
about 1 minute.
Resetting the base
When you reset your base, all the base
parameters are reset to their initial values
(factory settings), your SMS are not deleted.
On the navigator key , press or
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET.. Press Valid. .
Select SET BASE. Press Valid. .
Select RESET BASE using or . Press
Valid. .
A confirmation screen will prompt you to
confirm your request:
• To reset the base, press Yes .
You can also put the base in
registration mode by pressing the
base button until the indicator
flashes.
Livre du D60_GB.book Page 38 Mercredi, 8. décembre 2004 10:01 10