Operation Manual

30
ANSWERING MACHINE
If you make a mistake while recording the
announcement, repeat the operations
described above until you are satisfied with
your announcement or press the key
during the playback of the announcement.
Returning to the pre-recorded
announcement
Press the key.
Repeatedly press the key until "o2" is
shown on the base display.
You will hear the following message: PRESS
OK TO ACTIVATE ANSWERING ONLY
MODE.
Press the key. The current
announcement is played back.
If you want to return to the pre-recorded
announcement, hold down the key
until you hear a beep.
You will hear the following message:
RECORD YOUR ANNOUNCEMENT
MESSAGE AFTER THE BEEP.
Press the key immediately after the
beep.
The pre-recorded (default) announcement is
now active again.
STOP
MENU
STOP
Listening to your messages
Press the key to listen to your
messages
-If you have any new messages, only those
will be played back, from the most recent to
the most ancient one.
-If you do not have any new messages, all
the old messages will be played back, from
the most recent to the most ancient one.
The date and the time the messages were
received are announced before each
message.
Listen again to the current message
Press the key during the playback of
the message.
Listen again to the previous
message
Press the key twice to hear the
previous message again.
Go to the next message
During playback of the message, press the
key to skip to the next message.
While listening to the messages, you
can increase the sound level by
pressing the key. To
decrease the sound level, press
the key.
To play back the new and the old
messages, hold the key
down for several moments.
Vol
+
Vol
-
LU 252117222C_D20V_EN.book Page 30 Mercredi, 24. août 2005 11:46 11