Installation guide

Installing Driver for Echelon LT-USB Adapter

1. Insert the CD that came with you USB adapter leaving the USB adapter unplugged. This will

install the hardware lesrequired to support the USB adapter.

2. Upgrade to Open LDV version 3.4. Go to the MASC CD and open the OpenLDV subdirectory.

Execute the OpenLDV340exe le and follow the prompts to install Open LDV.

3. Now plug the LT-USB adapter into an open USB port. If this is the rst USB adapter this

computer has loaded it will be assigned to port “Lon1”. The PC now has all the information to

properly load the new MASC drivers. If there are any problems with this go to Start, Control

Panel, LonWorks Interfaces. Under the USB tab (with the USB adapter plugged in) you should

have a network port called LON1.

Installing Hardware Driver for iLon-10 (LT-EA-10) Adapter

1. Install and insert the CD that came with the iLon-10 adapter. Execute the setup.exe le, follow the prompts and the

CD will install the hardware drivers required to support the devices.

2. Upgrade to Open LDV version 3.4. Go to the MASC CD and open the OpenLDV subdirectory. Execute the

OpenLDV340 exe le and follow the prompts to install Open LDV.

3. The PC will need to be set to a compatible IP address to 192.168.1.xxx, Subnet 255.255.255.0.

4. Now plug is the LT-EA-10 (iLon-10) adapter into a network port. Using Windows Internet Explorer set the iLon’s IP

address of the iLon-10 to an IP address compatible with the network you need to run on. It needs to be something

other than the default address of 192.168.1.222

a. You connect to the device in Explorer with http://192.168.1.222/confg

b. User name ilon, Password ilon

c. If any free software display, make sure to allow connections for that device.

d. Change the IP address in the IP address eld

e. Set the Subnet Mask to something compatible with the network it will run on. Most networks are set at

255.255.255.0

f. Scroll down and click Submit

g. To verify the changes have been down properly you can click on the provided link to connect to the adapter

again or go to the next step.

REV 2.0