Installation guide

Card Readers

The MAC-4R support up to (4) wiegand output readers. The panel default is set to a standard 26

bit format, but can be changed to support any format up to 48 bit codes in the software. If PIN’s are

required, the panel supports the 8-bit burst keypad. The installer should follow the card reader manu-

facturer’s recommendations for wire-type, gauge, and shielding. Cabling should be an independent

run of shielded cable with shields tied to ground at controller location.

A valid card read will toggle LED1 for the pulse time set on the Reader Settings Tab.

LED2 is optional, many people use it to control a beeber.

REV 2.0