Installation guide

SLTA-10
The Serial Lon-Talk Adapter connects to the server PC via an RS-232 connection. Distance limita-
tions are 50’ maximum with low cap cable. All communications are verifed between the controllers
and computer.
SLTA-10 typical dipswitch settings
Switch Settings
1 Buffered Link/ Alert Ack. protocol Off
2 Remote Host/ Local Host Off
3 Net disables after reset/ Net Always Enabled Off
4 NSI Firmware/ SLTAFirmware Off
5 Autobaud Enable/ Autobaud disabled Off
6 Baud rate 19,200 On
7 Baud rate 9,600 Off
8 Baud rate 2,400 Off
SLTA-10 Side View Switch Settings
14
REV 2.0