Operation Manual

19
BASE SETTINGS
Modifying the pause duration
If you connect your telephone to a private
automatic branch exchange, you may need
to modify the pause duration in order to use
your telephone correctly. Four
preprogrammed durations are proposed on
the list, the correspondence between the
number of the list and the duration is the
following.
On the navigator key , press  or  until
the BASE SET screen is displayed, press
OK to confirm.
Select PAUSE DURA using  or . Press
OK.
An information screen presents the current
pause duration.
• To keep the same time, press C.
• To modify the time, press OK. Select the
new pause time using  or . Press
OK.
To exit the menu, press the red key .
number
corresponding
duration
11 second
2 1,5 second
3 2 seconds
4 3 seconds
To enter the pause mode during
dialling, press the
 key until letter
P appears.
Modifying the base code
The base code (0000 being the default
setting) is required to access certain security
functions. It must be composed of 4 digits
miminum up to 8 digits maximum.
On the navigator key , press  or  until
the BASE SET screen is displayed, press
OK to confirm.
Select CHANGE CODE using  or . Press
OK.
Enter the old base code using the keypad
(default is 0000). Press OK.
Enter the new base code using the keypad.
Press OK.
Confirm by entering the new base code
again. Press OK.
To exit the menu, press the red key .
Re-initialize the base
When you re-initialize your base, all the base
parameters are reset to their initial values
(factory settings).
On the navigator key , press  or  until
the BASE SET screen is displayed, press
OK to confirm.
Note carefully the new base code on
the back cover, you will need it to
modify some parameters.
LU 251619615_D20T_GB_SAGEM.book Page 19 Jeudi, 26. août 2004 4:54 16