Operation Manual

11. CHANGING THE LAMP UNIT

Only replace the old lamp unit with authorised model RL 1080A, reference number Sagem 251282989.

The old lamp unit must be recycled (contact your recycling agency to obtain the address of the nearest

depot).

WARNING

1. You must only change the lamp unit, when the appliance is switched off and mains cable

disconnected from the wall socket.

2. Never try to replace the lamp unit immediately after the Flat Screen DLP™ has been switched off.

So that the lamp is completely cooled down, wait at least 1 hour before changing the lamp unit.

3. Only use the tool provider to change the lamp unit.

Never touch any wires or the bulb itself.

4. Make sure that you tighten all the screws and do not leave any foreign bodies inside the

appliance.

Remove the front panel by gripping it on each

side and pull it towards you.

Unscrew the protection panel (use a Phillips

screwdriver) and remove the panel, taking care

to retain the screws.

ENGLISH