Operation Manual

7.3. Configuration of computer sources
Press the MENU button, then choose "INSTAL" using
the B button and validate with OK.
Choose "PC DATA" then validate with OK.
This option allows you to adjust the source coming from
your PC in VGA mode. (Entries in DVI D mode do not need
this adjustment).
Horizontal position: press C to move the picture to the
left and B to move it to the right.
Vertical position: Press B or C to move the picture to
the top or bottom.
Frequency: modifies the data display frequency so that it
corresponds to the frequency of your computer's graphics
card. When a flashing vertical bar appears, use this function
to adjust the frequency.
Phase: this enables finer synchronisation with your
computer's graphics card. When an unstable or flashing
page occurs, use this tuning.
Automatic mode: yes/no carries out automatic tuning.
Resolutions accepted (DVI-D and VGA entries)
To ensure that the projection display is operating correctly
with your computer make sure that you configure the
display mode of your graphics card to a resolution lower
than 1024 x 768.
NB: Optimum stability is achieved with a frequency of 60 Hz
(consult the documentation for your PC to configure it).
14
SAISIR
_ _ _ _
MODIF. CODE
CONFIG. USINE
CODE
VERROU
CHAINE
MODIF. CODE
CONFIG. USINE
CODE CODE
PROTECTION VERROU
SOURCES CHAINE
DONNEES PC
RECHERCHE
IMAGE AUDIO OPTIONS INSTAL.
CODE
PROTECTION
SOURCES
PC DATA
SEARCH
MODE HP INT.
HORIZONTAL 5
YES
VERTICAL 10
FREQUENCY -3
PHASE 0
AUTO IMAGE
Horizontal Vertical Hz
640 x 480 60
640 x 480 66
640 x 480 72
640 x 480 75
640 x 480 85
800 x 600 60
800 x 600 72
800 x 600 75
800 x 600 85
1024 x 768 60
1024 x 768 70
1024 x 768 75
1152 x 864 60
1152 x 864 70
1280 x 720 60
1280 x 1024 60