Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-58 Sagem Communications document. Reproduction and disclosure prohibited
Field Action Default
PPP IP extension
Check the box to allocate your computer the
public address obtained from the DHCP
server of your Internet Service Provider (ISP).
Your router will then act as a bridge between
the server and your computer.
Not checked
Use Static IP Address
Check the box to use the static IP address.
Not checked
IP Address:
5
Enter the static IP address
0.0.0.0
Configure PPP MTU
Enter an MTU (Maximum Transfer Unit) value
between 38 and 1492 (see Note).
1492
Enable PPP Debug mode
Check the box to use the PPP Debug mode.
In the event of connection failure, this option
will enable you to trace a possible problem in
the SYSLOG file.
Box
Not checked
Note: The MTU specifies the maximum size of the data used for packets expressed as a
number of bytes.
• Click on the Next button to continue configuring the remote network (WAN) in PPPoA
mode.
5
This field only appears when the "Use Static IP Address" field is activated (box checked).