Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-52 Sagem Communications document. Reproduction and disclosure prohibited
5.9 Advanced Setup
Object: This menu is used to configure the specific parameters for your router.
This menu must only be used by experienced users.
This section contains the following nine menus:
• WAN (see subsection 5.9.1),
• LAN (see subsection 5.9.2),
• Security (see subsection 5.9.3),
• Quality of Service (see subsection 5.9.4)(see note),
• Routing see subsection 5.9.5),
• DNS (see subsection 5.9.6),
• DSL (see subsection 5.9.7),
• Port Mapping (see subsection 5.9.8),
• Certificate (see subsection 5.9.9).
Note: This menu only appears if you checked the "Enable Quality Of Service" box in the
WAN interface configuration screen (see Advanced Setup/WAN –
subsection 5.9.1/Add).
5.9.1 WAN
Object: This menu is associated with the remote network. It is used to display the list of all the
configured PVCs, to add PVCs or remove them.
• Select the WAN menu in the Advanced Setup section to display the following screen: