Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page 5-39
5.7.5 Quality of Service
Object: The Wi-Fi quality of service for your router conforms to the WMM (Wifi MultiMedia)
specification. This standard improves the performances of Wi-Fi links by acting on
the data flows (packet size, bit rates, etc.) and the length of queues while respecting
bandwidth requirements (managed by the router).
• Select the Quality of Service menu in the Wireless section to display the following screen:
Field Meaning Default
WMM (Wi-Fi Multimedia)
In the scroll down list, select the activation
(Enabled) or deactivation (Disabled) of the
WMM support.
Disabled
WMM No Acknowledgement
Note: The scroll down list may only be
operational if the "WMM (Wi-Fi
Multimedia)" field is activated.
In the scroll down list, select Enabled or
Disabled to permit or prohibit a more effective
bit rate of the data flow with, on the other hand,
a higher error rate.
Greyed
out