Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-34 Sagem Communications document. Reproduction and disclosure prohibited
Add
• Click on the Add button to add a MAC address to be filtered (address of a computer
authorised to connect to a wireless network).
Note: The MAC address can be added automatically at the time of the Wi-Fi installation, by
a short push on button “REG”.
After approximately 5 minutes, the new address fits in the list and F@st
TM
2604
passes in mode of filtering (MAC Restrict Mode) “Allow” to authorize only the
computers whose MAC address appears in the list to be connected to your router.