Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-16 Sagem Communications document. Reproduction and disclosure prohibited
Field Meaning Default
Select SSID
Select the "SSID" of your choice from the scroll
down list (sagem or Guest).
sagem
Network Authentication
From the scroll down list, select the security
adapted to your router's wireless network. The list
suggests the following choices:
• Open : There is no protection for the wireless
network (Open System).
• Shared :
• 802.1x : Activation of the 802.1x standard,
• WPA : Activation of WPA (Wireless Protected
Access),
• WPA-PSK : Activation of WPA-PSK,
• WPA2 : Activation of WPA2,
• WPA2-PSK : Activation of WPA2-PSK,
• Mixed WPA2/WPA : Activation of
Mixed WPA2/WPA,
• Mixed WPA2/WPA-PSK : Activation of
Mixed WPA2/WPA-PSK,
This choice will modify the Wireless configuration
screen.
Open
WEP Encryption
Select from the scroll down list:
• Disabled to not use WEP encryption.
• Enabled to use WE encryption
(see subsection 5.7.1.2 - WEP).
Disabled