Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page 5-13
WEP
• Select the "WEP" encryption mode from the scroll down list; the following screen appears:
Field Action/Meaning Default:
Encryption Strength
Select 64-bit or 128-bit for an encryption at 64 bits or
128 bits respectively.
128-bit
Key phrase
Enter a phrase that consists of up to 15 alphanumeric
characters then click the Generate Keys button.
Empty
Current network key
Select a key from the four suggested. The emission
key is used to encrypt the data sent by your
computer.
1
Network key x (1 to 4)
The WEP key is customised for your router.
You may modify the keys by entering them directly
into the boxes.
The characters are "0" to "9" and "A" to "F".
Empty
Store the key phrase and the keys in a safe location.
Do not write them in a file on your computer.