Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-10 Sagem Communications document. Reproduction and disclosure prohibited
5.7 Wireless
Object: This menu lets you activate a network and also allows you to configure all the basic
and advanced parameters of a wireless network.
This section contains the following five menus:
• Basic (see subsection 5.7.1),
• Security (see subsection 5.7.2),
• MAC Filter (see subsection 5.7.3),
• Advanced (see subsection 5.7.4),
• Quality of Service (see subsection 5.7.5).
The Security, MAC Filter, Advanced and Quality of Service menus are used
to configure the advanced parameters in the Wireless section. These menus are
only displayed if, in the Basic menu, the "Enable Advanced Wireless
Configuration" box is checked (not checked by default).
These menus must only be accessed/modified by experienced users.
5.7.1 Basic
• Select the Basic menu in the Wireless section to display the following wireless network
configuration screen: