Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
4 - Configuration of network parameters
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page 4-3
1) Configuring as a DHCP client
In Windows XP
• click Start/Control Panel/Network Connections.
• right-click the appropriate network, and then select Properties; the
Local Area Connection Properties appears.
• select the protocol TCP/IP of the network card, and then click the Properties button; the
screen Internet Protocol (TCP/IP) Properties appears.
• select the general tab, then the case "Obtain an IP address automatically" and the case
"Obtain the addresses of the DNS servers automatically".
• click the OK button to confirm your choice.