Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
Annex G - Connectors
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page G-3
G.3 Pinouts of the "ETH1", "ETH2", "ETH3" and
"ETH4" connectors
The Ethernet interface is connected to the equipment using a RJ45
fixed connector (8 pins).
12345678
Contact No Signal Meaning
1TXD+
(+) Emission to terminal
2 TXD- (-) Emission to terminal
3 RXD+ (+) Reception of terminal
4 NC Not connected
5 NC Not connected
6 RXD- (-) Reception of terminal
7 NC Not connected
8 NC Not connected
The Ethernet port is self-detecting. You can use either straight or crossed cables. An
emission or reception signal is detected automatically.