Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
Annex G - Connectors
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page G-2 Sagem Communications document. Reproduction and disclosure prohibited
G.1 Pinouts of the " ADSL" connector
The equipment is connected to ADSL using a RJ11 fixed connector (6 pins).
123456
Contact N° Signal Meaning
3 LINE-A Line A signal
4 LINE-B Line B signal
1 NC Not connected
2 NC Not connected
5 NC Not connected
6 NC Not connected
G.2 Pinouts of the "PWR" connector
The mains unit is connected to the equipment using the miniature fixed connector of the case.
Contact No Signal Meaning
Intérieur +12 V Connexion DC "+"
Extérieur Masse Connexion DC "-"