Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
Annexe E - Configuration par défaut
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page E-2 Sagem Communications document. Reproduction and disclosure prohibited
This section indicates the values of the default parameters of your
SAGEM F@st
TM
2604/2644 when it leaves the factory.
These default parameters can be modified by a particular preconfiguration of your
SAGEM F@st
TM
2604/2644.
E.1 Default username and password
Username admin
Password admin
The Username and Password can be different according to the ISP (Internet Service
Provider).
E.2 Default configuration for the local network(LAN)
The following table gives the values of the principal LAN parameters of your SAGEM F@st
TM
2604/2644 (ETH1 to ETH4) :
LAN characteristics Value State
ETH1 IP address ( )
192.168.1.1/24 Internet and HTTP configurator access (bridged)
ETH2 IP address ( )
ETH3 IP address ( )
ETH4 IP address ( )
BROADCAST, ARP, MULTICAST _ Activated
Router _ The LAN traffic is routed to your ISP
NAT/PAT _ Activated