Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
Annex B - Warnings for safety
SAGEM F@stâ„¢ 2604/2644 Reference Manual - 253080888-A
Page B-2 Sagem Communications document. Reproduction and disclosure prohibited
B.1 Warnings for safety
The router is in compliance with standard EN 60950 Ed December 2001.
The safety levels in the sense of this standard are as follows:
B.1.1 Safety levels in relation to the case
Connecteurs Position Safety level
Adaptator
Primary Power Supply port HPV
1
PWR
DC Power Supply port SELV
2
ADSL
ADSL port TNV3
3
ETH1 to ETH4
Ethernet port SELV
2
B.2 EC compliance declaration
This equipment can be operated in the EU without restrictions indoor, but cannot be operated
outdoors in France in the whole of the band until further notice.
Sagem Communications declares that the SAGEM F@st
TM
2604/2644 product conforms to
the requirements of European directives 1999/5/CE and the essential requirements of directives
2004/108/CE and 2006/95/CE.
The EC déclaration of conformity for the SAGEM F@st
TM
2604/2644 product is made within the
framework of the R&TTE directive.
1
Hazardous Primary Voltage circuit
2
Safety Extra Low Voltage Circuit
3
Level 3 Telecommunication Network Voltage