Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
2 - Description and connection of router
SAGEM F@st™ 2604/2444 Reference Manual - 253080888-A
Page 2-4 Sagem Communications document. Reproduction and disclosure prohibited
2.1.2 LEDs
The different LEDs of the figure above are described in the following table:
Status Colour
Green Power On ADSL Up
Wi-Fi
activated
A PPP session has been created
Lit
steady
Amber
x x x ADSL link is established
Flickering Green x x Wi-Fi Tx/Rx Tx/Rx traffic
Blinking Amber x x x ADS is training
Slow
Blinking
Green
x Line not detected Wi-Fi pairing x
Fast
Blinking
Green
x
ADSL
synchronisation
training
x x
Off Green Power Off
Wi-Fi
deactivated
Power Off
or
Bridge mode
or
ADSL down
Status Colour 1 2 3 4
Lit on steady
Ethernet port (ETH1, ETH2, ETH3 or ETH4) has detected a link with
100 Mbps device
Flickering
Green
Tx/Rx traffic at 100 Mbps
Lit on steady
Ethernet port (ETH1, ETH2, ETH3 or ETH4) has detected a link with
10 Mbps device
Flickering
Amber
Tx/Rx traffic at 10 Mbit/s
Off x No link detected on the Ethernet port