Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
8 - Updating the application
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 8-2 Sagem Communications document. Reproduction and disclosure prohibited
Three possibilities are offered to you for updating the firmware:
• via HTTP,
• via TR69 protocol.
If necessary, the new firmware version download is performed automatically on starting up the
router.
Throughout the download procedure (up to five minutes), you must:
• not power down the router,
• not disconnect from the ADSL line.
During the download, the eight LEDs of your router lights in turn except the
LED that
stays on steady.
When the download is finished, your router restarts automatically to the new firmware version.
To check that the new version has been correctly downloaded, click top left in
the home screen, on the Status / Summary heading ; the last software
version displays in the "Software Version" field.
HTTP update
You can download the new firmware to update your router as indicated in subsection 5.5.7 of
the HTTP configurator.
TR69 protocol
Operators can use "TR69" protocol to upgrade the router's firmware from an HTTP or FTP
server.