Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-146 Sagem Communications document. Reproduction and disclosure prohibited
5.11.6 Access Control
This menu contains the following three sub menus:
• Services (see subsection 5.11.6.1),
• IP Address (see subsection 5.11.6.2),
• Passwords (see subsection 5.11.6.3).
5.11.6.1 Services
Object: this sub menu is used to activate or deactivate Services such as FTP, FTPP etc.
• Select the Services sub menu in the Access Control menu of the Management section to
display the following screen:
The table displayed in the screen above indicates that the services listed such as FTP, HTTP,
ICMP, SNMP, SSH, TELNET and TFTP are all activated ("Enable" box checked) on the local
network (LAN) and deactivated ("Enable" box not checked) on the remote network (WAN).
Check the Enable box to activate the selected service on the local network (LAN) or on the
remote network (WAN).
Note: The ICMP service is always activated on the local network (LAN) and may be
activated or deactivated on the remote network (WAN).