Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
2 - Description and connection of router
SAGEM F@st™ 2604/2444 Reference Manual - 253080888-A
Page 2-2 Sagem Communications document. Reproduction and disclosure prohibited
2.1 Description
Figure 2.1 gives an overview of a router (SAGEM F@st
TM
2604 or SAGEM F@st
TM
2644).
Figure 2.1 - Overview of case
This case consists principally of a lid and a base. Inside is a printed circuit equipped with
electronic components.
The components of the base different according to the equipment (SAGEM F@st
TM
2604 or
SAGEM F@st
TM
2644)(see § 2.1.1)
The front face of the lid has eight display LEDs (see § 2.1.2).
The base has the LED ideograms, SAGEM's logo or the operator's logo.
Below the base is a label on which the product's identification code, series number and barcode
are shown.