Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-140 Sagem Communications document. Reproduction and disclosure prohibited
5.11.3 SNMP Agent
Subject: This menu allows to configure your SNMP agent. SNMP (Simple Network
Management Protocol) allows to manage the elements of network from a
supervision station also called "Manager".
Select SNMP Agent menu in the Management section ; the following screen appears:
In the SNMP Agent field, click on the relevant box to Disable or Enable your SNMP Agent.
Inform the fields as shown in the table herafter:
Read Community
You can to preserve "public" or enter another
name for the SNMP Agent (for example the
computer connected to your router).
Note: These rights are Read only (RO).
public
Set Community
You can to preserve "private" or enter another
name for the SNMP Manager integrated into your
router.
Note: The rights are Read / Write (RW).
private
System Name
Enter the name of the SNMP server. Sagem
System Location
Enter the place where is your SNMP server. unknown