Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-134 Sagem Communications document. Reproduction and disclosure prohibited
5.11.1.3 Restore Default
Object: This menu is used to return to factory configuration.
The existing configuration is completely overwritten.
• Select the Restore Default sub menu in the Settings menu of the Management section to
display the following screen:
• click on the Restore Default Settings button and the following screen appears:
• Click on the OK button if you really want to return to the factory configuration.
A few moments after, the screen of the "Internet Connection" menu appears. Refer to paragraph
5.6.
All the LEDs go off except for the green " " LED (WLAN) (if the wired network is
activated);
the green " " LED (PWR) then all the LEDs and the process for
returning to the factory configuration starts. It lasts for around 2 minutes.