Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page 5-115
5.9.9 Certificate
This menu contains 2 sub-menus:
• Local (see subsection 5.9.9.1),
• Trusted CA (see subsection 5.9.9.2).
5.9.9.1 Local
Object: This menu is used to manage your router's identity certificates. These certificates,
which are used by TR-69 (in SSL mode), enable the mutual authentication of the CPE
and the ACS.
• Select the Local sub-menu in the Certificate menu in the Advanced Setup section to
display the following screen:
Field Meaning
Name
Name of the certificate.
In Use
Indicates whether the certificate can be used or not.
Subject
Summarises the main characteristics of the certificate.
Type
Indicates the status of the certificate (e.g.: request).
Action
Select the action from the list: view, load signed certificate,
remove.