Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-110 Sagem Communications document. Reproduction and disclosure prohibited
5.9.8 Port Mapping
Object: This menu is used to host a service (Video, Data, SIP) on an interface (ETH or Wi-Fi)
of your router.
• Select the Port Mapping menu in the Advanced Setup section to display the following
screen:
Field Meaning Default
Enable virtual ports on
If the box is not checked, the Ethernet 1 to 4
(ENET (1-4)) ports are gathered and seen like
only one virtual port.
When the box is checked, these ports are
independently seen but a fall of the
performances of the transfers between ports
is noted.
Box
not checked