Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-104 Sagem Communications document. Reproduction and disclosure prohibited
5.9.6.2 Dynamic DNS
Subject: Enables a web surfer to access your router (having no fixed IP address but only a
DNS entry) through a dynamic DNS provider such as, for example, dyndns.org.
In the Advanced setup section, select the DNS menu then select the Dynamic DNS sub-
menu.
The following screen appears.
On the screen above, The fields of the table are detailed in the next subsection (Add).
Note: On the screen above, The fields of the table are detailed in the next subsection (Add).
The "Service" field is automatically filled by the system in "dyndns".