Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page 5-101
5.9.5.3 RIP
Object: The "RIP" protocol (Routing Information Protocol) lets you tell routers the distance
(number of hops) which separates them.
This protocol only takes account of the distance between two machines in terms of
hops.
• Select the RIP sub-menu in the Routing menu in the Advanced Setup section to display
the following screen:
Field Action/Meaning Default
Global RIP Mode
Check the appropriate box to activate (Enabled)
or deactivate (Disabled) the RIP function
(Routing Information Protocol).
Disabled
Interface
Created or native interface.
Br0
VPI/VCI
VPI/VCI associated with the interface.
(LAN)
Version
Select the RIP version of your choice from the
scroll down list.
• 1 for RIP1,
• 2 for RIP2,
• Both.
2