Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-100 Sagem Communications document. Reproduction and disclosure prohibited
Add
• Click on the Add button to display the following screen:
Field Action Default
Destination Network
Address
Enter the IP address of the remote
network.
Empty
Subnet Mask
Enter the remote subnet mask.
Empty
Use Gateway IP Address
Check the appropriate box then enter the
IP address of the gateway.
Box
not checked
Empty
Use Interface
Select the interface you want to use from
the scroll down list (pppoa_8_35_1 for
example).
Box checked
Interface
used